Ergotron WorkFit-B User's Guide download pdf (Page 14)

14 of 18

888-24-227-G-00 rev. B • 07/13

826-901-00

WARNING

Moving Parts Can Crush And Cut

IMPACT HAZARD

Failure to heed this warning may result in

serious personal injury or property damage!

For More information and instructions visit www.ergotron.com

or contact Ergotron Customer Care at 1-800-888-8458

Minimize Lift Strength BEFORE:

- Removing Mounted Equipment

and

Insert 4 Stop Screws BEFORE:

- Shipping or Storing (i.e. when Desk is not upright).

To Minimize Lift Strength

Refer to installation manual for instructions on

how to minimize lift strength.

To Insert 4 Stop Screws

Refer to installation manual for instructions on

installing stop screws.

Adjustment Step

Install all equipment.

CAUTION! Make sure you leave 20” (508mm)

of slack in all equipment cables to allow the

worksurface to raise up it’s full 20” (508mm).

Failure to allow enough slack in equipment

cables may cause cables to get pulled,

equipment to fall o desk and may result in

product damage and or personal injury.

Set-up Steps

Important! You will need to adjust this product after installation is complete. Make sure all your equipment is properly

installed on the product before attempting adjustments. This product should move smoothly and easily through

the full range of motion and stay where you set it. If movements are too easy or di cult or if product does not stay

in desired positions, follow the adjustment instructions to create smooth and easy movements. Depending on your

product and the adjustment, it may take many turns to notice a di erence. Any time equipment is added or removed

from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps

to ensure safe and optimum operation.

1 2 ... 9 10 11 12 13 14 15 16 17 18

No comments

Ergotron WorkFit-B User's Guide Page 14