10 of 18
888-24-227-G-00 rev. B • 07/13
9
a
b
c d
ST3.9 x 16mm
4x
#46, Ø 0.081” (2mm)
If your brake release handle is not aligned with the front edge of your worksurface and you
would like it to be, follow these instructions to relocate the brake release handle.
Relocate brake release handle along front edge of worksurface and next to the inside of
the leg only. DO NOT attach brake release handle in front of or to the outside of the leg.
Make sure cable has enough slack to allow worksurface to fully extend up and down.
Set-up Steps
Comments to this Manuals