888-24-228-G-00 rev.B • 07/13
13 of 15
14mm
WARNING. Before removing mounted equipment (monitor, arm, stand CPU, etc.), from desk, or
to prepare for shipping or storing the desk it is extremely important to minimize the lift strength.
Failure to install these instructions may cause lift engine to expand rapidly and may result in
equipment damage and or personal injury.
WARNING! DO NOT tip desk over to adjust. Only perform
adjustment while desk is upright. Failure to follow these
instructions may cause the lift engine to expand rapidly and may
result in equipment damage and or personal injury.
1. Release the hand brake and move the worksurface up to highest level.
2. To minimize lift strength, turn adjustment bolt counter clockwise using a 14mm socket.
Keep adjusting until the wrench stops turning.
3. Once at minimum lift strength it is ok to remove mounted equipment.
APPENDIX A - Minimize Lift Strength
Comments to this Manuals